Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D3299-08
Standard Specification for Filament-Wound Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
Automaticky preložený názov:
Štandardné špecifikácie pre vlákna - rán skleným vláknom vystužený termosetickou živicou odolné proti korózii nádrže
NORMA vydaná dňa 15.11.2008
Informácie o norme:
Označenie normy: ASTM D3299-08
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.11.2008
Kód tovaru: NS-23177
Počet strán: 17
Približná hmotnosť: 51 g (0.11 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D3299-08 :
Keywords:
above ground, atmospheric, filament wound, polyester, tank, vinylester, Joint construction, Laminates (plastic), Liquids, Outdoor service equipment, Vinyl ester plastics, Polyester plastics--specifications, Reinforced thermosetting plastics (RTP)--specifications, Resins--specifications, Storage containers/tanks--specifications, Structural tanks, Tanks--specifications, Tolerances--plastics, Aboveground storage tanks (AST), Chemical resistance--plastics, Chemical-resistant nonmetallic materials
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||||||||
|
1.1 This specification covers cylindrical tanks fabricated by filament winding for above-ground vertical installation, to contain aggressive chemicals at atmospheric pressure as classified herein, and made of a commercial-grade polyester or vinylester resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance. 1.2 This specification does not cover the design of vessels intended for pressure above atmospheric, vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1—Special design consideration should be given to vessels subject to superimposed mechanical forces, such as earthquakes, wind load, or agitation, and to vessels subject to service temperature in excess of 180°F (82°C), and to vessels with unsupported bottoms. Note 2—There is no similar or equivalent ISO standard. 1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||
|
Doporučujeme:
