Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D3165-00
Standard Test Method for Strength Properties of Adhesives in Shear by Tension Loading of Single-Lap-Joint Laminated Assemblies
Automaticky preložený názov:
Štandardná skúšobná metóda pre pevnostné vlastnosti lepidiel v šmyku ťahom Nakladanie Single - Lap - Joint Vrstvené Assemblies
NORMA vydaná dňa 10.5.2000
Informácie o norme:
Označenie normy: ASTM D3165-00
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.5.2000
Kód tovaru: NS-22689
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D3165-00 :
Keywords:
adhesive-bonded plast, strength properties of adhesives in shear, by tension loading of, single-lap-joint laminated assemblies, test, , Adhesives-structural, strength properties of adhesives in shear, by tension loading of, single-lap-joint laminated assemblies, test, , Bond strength-adhesives (metal-to-metal), strength properties of adhesives in shear, by tension loading of, single-lap-joint laminated assemblies, test, , Laminates
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||
|
1.1 This test method (Note 1) is intended for determining the comparative shear strengths of adhesives in large area joints when tested on a standard single-lap-joint specimen and under specified conditions of preparation and testing. Adhesives respond differently in small versus large area joints (Note 2). Note 1-While this test method is intended for use in metal-to-metal applications, it may be used for measuring the shear properties of adhesives using plastic adherends, provided consideration is given to the thickness and rigidity of the plastic adherends. Doublers may be required for plastic adherends to prevent bearing failure in the adherends. Note 2-This variation can be influenced by adhesive density, flow characteristics, cure rate, gel time, carrier composition, entrapped volatiles, volatiles released during cure, etc. and also by cure cycle variables including: temperature, time, pressure, rise rate to temperature, cool-down rate, etc.1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||
|
Doporučujeme:
