Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D3032-21
Standard Test Methods for Hookup Wire Insulation
NORMA vydaná dňa 1.1.2021
Informácie o norme:
Označenie normy: ASTM D3032-21
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2021
Kód tovaru: NS-1018235
Počet strán: 40
Približná hmotnosť: 120 g (0.26 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D3032-21 :
Keywords:
ambient temperature, arcing, arc-propagation, arc-tracking, atmospheric pressure, breakdown voltage, cable, circuit breakers, current limiting, cuts, degradation, dropping apparatus, dry-arcing, electrical insulation, electrolyte, extinction voltage, flame propagation, flame spread, flame test, flammability, hookup wire, insulation thickness, moisture, open-circuit detection, partial discharge, power supply, safe voltage, scintillation, service condition, short-circuit detection
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1?These test methods cover procedures for testing hookup wire. 1.2?For the purposes of these test methods, hookup wire insulation includes all components of the insulation system used on single insulated conductors or an assembly of single insulated conductors such as a cable bundle and harness or flat ribbon cable. The insulating materials include not only the primary insulation over the conductor, but also insulating jackets over shielded constructions. 1.3?These test methods and their locations are as follows:
1.4?The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.5?This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not, by itself, incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions. 1.6?Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests. 1.7?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
