Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D2650-99
Standard Test Method for Chemical Composition of Gases By Mass Spectrometry
Automaticky preložený názov:
Štandardná skúšobná metóda pre chemické zloženie plynov hmotnostnej spektrometrie
NORMA vydaná dňa 10.4.1999
Informácie o norme:
Označenie normy: ASTM D2650-99
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.4.1999
Kód tovaru: NS-21024
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D2650-99 :
Keywords:
Atmospheric analysis, Butane, Composition analysis-gases, Composition analysis-petroleum products, Gas analysis, Gas composition, Gasoline, Hydrogen content-petroleum products, Mass spectrometry, Petroleum/petroleum products, Refinery gases, gases-chemical composition, by mass spectrometry, test, ICS Number Code 71.040.40 (Chemical analysis)
Doplňujúce informácie
| 1. Scope | ||||||||||
|
1.1 This test method covers the quantitative analysis of gases containing specific combinations of the following components: hydrogen; hydrocarbons with up to six carbon atoms per molecule; carbon monoxide; carbon dioxide; mercaptans with one or two carbon atoms per molecule; hydrogen sulfide; and air (nitrogen, oxygen, and argon). This test method cannot be used for the determination of constituents present in amounts less than 0.1 mole%. Dimethylbutanes are assumed absent unless specifically sought. Note 1-Although experimental procedures described herein are uniform, calculation procedures vary with application. The following influences guide the selection of a particular calculation: qualitative mixture composition; minimum error due to components presumed absent; minimum cross interference between known components; maximum sensitivity to known components; low frequency and complexity of calibration; and type of computing machinery. Because of these influences, a tabulation of calculation procedures recommended for stated applications is presented in Section 12 (Table 1). Note 2-This test method was developed on Consolidated Electrodynamics Corporation Type 103 Mass Spectrometers. Users of other instruments may have to modify operating parameters and the calibration procedure.1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 6. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
Doporučujeme:
