Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Reinforced Epoxy Resin Gas Pressure Pipe and Fittings
Automaticky preložený názov:
Štandardné špecifikácie pre vystužené epoxidové živice plynu tlakového potrubia a armatúry
NORMA vydaná dňa 15.11.2011
Označenie normy: ASTM D2517-06(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.11.2011
Kód tovaru: NS-20634
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
filament wound, compression molded, configuration of joining system, rupture srength, crush strength, chemical resistance, apparent tensile properties, adhesive, Shear testing--adhesives, Compression-molded plastic specimens, Configuration of joining system, Filament-wound plastic pipe, Gas pressure systems/applications--specifications, Reinforced thermosetting-resin pipe (RTRP)--specifications, ICS Number Code 23.040.20 (Plastic pipes), 23.040.45 (Plastic fittings)
1. Scope | ||||||||||||||||||||||||||||||||||||||
1.1 This specification covers requirements and methods of test for materials, dimensions and tolerances, hydrostatic-burst strength, chemical resistance, and longitudinal tensile properties, for reinforced epoxy resin pipe and fittings for use in gas mains and services for direct burial and insertion applications. The pipe and fittings covered by this specification are intended for use in the distribution of natural gas, petroleum fuels (propane–air and propane–butane vapor mixtures), manufactured and mixed gases where resistance to gas permeation, toughness, resistance to corrosion, aging, and deterioration from water, gas, and gas additives are required. Methods of marking are also given. Design considerations are discussed in Appendix X1. 1.2 The values in SI units are to be regarded as the standard. 1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—There is no known ISO equivalent to this standard. 1.4 A recommended inplant quality control program is given in Appendix X2. |
||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Historická
1.12.2010
Historická
1.5.2011
Historická
1.4.2012
Historická
1.3.2011
Historická
1.8.2013
Historická
1.8.2013
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.