Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D2457-13
Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics
Automaticky preložený názov:
Štandardná skúšobná metóda pre zrkadlového lesku plastových fólií a pevných plastov
NORMA vydaná dňa 1.4.2013
Informácie o norme:
Označenie normy: ASTM D2457-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2013
Kód tovaru: NS-20422
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D2457-13 :
Keywords:
gloss, plastic films, solid plastics, ICS Number Code 83.140.10 (Films and sheets)
Doplňujúce informácie
| Significance and Use | ||||||||||||||
|
4.1 Specular gloss is used primarily as a measure of the shiny appearance of films and surfaces. Precise comparisons of gloss values are meaningful only when they refer to the same measurement procedure and same general type of material. In particular, gloss values for transparent films should not be compared with those for opaque films, and vice versa. Gloss is a complex attribute of a surface which cannot be completely measured by any single number. 4.2 Specular gloss usually varies with surface smoothness and flatness. It is sometimes used for comparative measurements of these surface properties. |
||||||||||||||
| 1. Scope | ||||||||||||||
|
1.1 This test method describes procedures for the measurement of gloss of plastic films and solid plastics, both opaque and transparent. It contains four separate gloss angles (Note 1): 1.1.1 60-deg, recommended for intermediate-gloss films, 1.1.2 20-deg, recommended for high-gloss films, 1.1.3 45-deg, recommended for intermediate and low-gloss films, 1.1.4 85-deg, recommended for intermediate and low gloss films, and 1.1.5 75-deg, recommended for plastic siding and soffit. 1.2 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
|
|
Standard Test Method for Specular Gloss
|
|
Standard Test Method for Reflectance Factor and Color by Spectrophotometry Using Bidirectional (45?:0? or 0?:45?) Geometry
|
|
Standard Test Method for 45-deg Specular Gloss of Ceramic Materials
|
|
Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) Siding
|
|
Standard Terminology of Appearance
|
|
Standard Test Method for Color and Color-Difference Measurement by Tristimulus Colorimetry
|
|
Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method |
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
