Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Weight Loss of Plasticizers on Heating (Withdrawn 2010)
Automaticky preložený názov:
Štandardná skúšobná metóda pre chudnutie zmäkčovadiel na vykurovanie ( Withdrawn 2010 )
NORMA vydaná dňa 1.1.2001
Označenie normy: ASTM D2288-97(2001)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2001
Kód tovaru: NS-19930
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
plasticizer, plasticizer volatility, ICS Number Code 83.040.30 (Auxiliary materials and additives for plast)
Significance and Use | ||||||||
The quantity of volatile components in a plasticizer has influence on fuming during processing, and the retention of flexibility and other properties in the end product (see 5.2). This test method may be used to measure the volatile components under closely controlled conditions. Results obtained by this test method are not strictly equivalent to those obtained during processing where conditions of temperature and air flow are quite different. Volatility is dependent upon air flow and temperature. Due to the difficulty of controlling air flow, results may vary widely between ovens. Therefore, control plasticizers shall be run simultaneously when making close comparisons. |
||||||||
1. Scope | ||||||||
1.1 This test method covers the determination of the relative volatility of plasticizers, or volatile contaminants, or both, at elevated temperatures. 1.2 The text of this test method references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this test method. 1.3 The values stated in SI units are to be regarded as the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1--There are no ISO standards covering the primary subject of this test method. |
||||||||
2. Referenced Documents | ||||||||
|
Posledná aktualizácia: 2024-11-21 (Počet položiek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.