Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards
NORMA vydaná dňa 1.4.2021
Označenie normy: ASTM D2162-21
Dátum vydania normy: 1.4.2021
Kód tovaru: NS-1022039
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
kinematic viscosity, master viscometers, viscosity oil standards,, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
Significance and Use | ||||||||||||||||||||||||||||
5.1?Because there are surface tension or kinematic viscosity differences, or both, between the primary standard (7.4) and kinematic viscosity standards (7.5), special procedures using master viscometers are required to step-up from the kinematic viscosity of the primary standard to the kinematic viscosities of oil standards. 5.2?Using master viscometers calibrated according to this practice, an operator can calibrate kinematic viscometers in accordance with Specifications D446. 5.3?Using viscosity oil standards established in this practice, an operator can calibrate kinematic viscometers in accordance with Specifications D446. |
||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||
1.1?This practice covers the calibration of master viscometers and viscosity oil standards, both of which may be used to calibrate routine viscometers as described in Test Method D445 and Specifications D446 over the temperature range from 15 ?C to 100 ?C. 1.2?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.2.1?The SI-based units for calibration constants and kinematic viscosities are mm2/s2 and mm 2/s, respectively. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||
|
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.