Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Assigning a Standard Commercial Moisture Content for Wool and its Products
NORMA vydaná dňa 1.7.2018
Označenie normy: ASTM D2118-18
Dátum vydania normy: 1.7.2018
Kód tovaru: NS-856834
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
ICS Number Code 59.060.10 (Natural fibres)
Significance and Use | ||||||||||
4.1 The purpose of this practice is to bring about uniformity of commercial moisture standards in all ASTM specifications relating to wool and its products. 4.2 This practice provides a recommended single value for a standardized commercial moisture content for wool and its products. This avoids difficulties encountered in calculating the amount of moisture-free fiber present in a given mass of wool in any one of the forms listed in 1.1.1 to 1.1.8 due to trade practices which recognize various commercial moisture allowance values used by certain segments of the trade. (See Test Method D584, Section 3.5, Table D1909,D1909 Note E, and the Tables in Practice D2720). 4.3 The recommended commercial moisture content should be used where it is desirable to avoid problems in determining moisture-free fiber content when the form of the wool is changed. For example: from scoured wool (12.0 % moisture content) to worsted yarn, dry spun (13.04 % moisture content). |
||||||||||
1. Scope | ||||||||||
1.1 This practice recommends that a single value be adopted for the commercial moisture content of wool in any of the following forms: 1.1.1 Scoured, 1.1.2 Carbonized and neutralized, 1.1.3 Noils, uncarbonized, 1.1.4 Top, oil or dry combed, 1.1.5 Yarn, worsted, 1.1.6 Yarn, woolen, 1.1.7 Yarn, hand knitting, or 1.1.8 Fabric. 1.2 Limitations—Grease wool, pulled wool, and wool with pH below 5.0 are excluded from this practice. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Posledná aktualizácia: 2024-11-24 (Počet položiek: 2 206 712)
© Copyright 2024 NORMSERVIS s.r.o.