Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D1796-11(2016)
Standard Test Method for Water and Sediment in Fuel Oils by the Centrifuge Method (Laboratory Procedure)
NORMA vydaná dňa 1.6.2016
Informácie o norme:
Označenie normy: ASTM D1796-11(2016)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2016
Kód tovaru: NS-642252
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D1796-11(2016) :
Keywords:
centrifuge, fuel oils, toluene saturation, water and sediment,, ICS Number Code 75.160.20 (Liquid fuels)
Doplňujúce informácie
| Significance and Use | ||||||||||||||||
|
4.1 The water and sediment content of fuel oil is significant because it can cause corrosion of equipment and problems in processing. A determination of water and sediment content is required to measure accurately net volumes of actual fuel oil in sales, taxation, exchanges, and custody transfers. 4.2 This test method may not be suitable for products that contain alcohols that are soluble in water. In cases where the impact on the results may be significant, the user is advised to consider using another test method, such as Test Method D6304. |
||||||||||||||||
| 1. Scope | ||||||||||||||||
|
1.1 This test method describes the laboratory determination of water and sediment in fuel oils in the range from 0 % to 30 % volume by means of the centrifuge procedure. Note 1: With some types of fuel oils such as residual fuel
oils or distillate fuel oils containing residual components, it is
difficult to obtain water or sediment contents with this test
method. When this situation is encountered, Test Method
D95 (API MPMS Chapter 10.5) or Test Method
D473 (API MPMS Chapter 10.1) may be
used.
Note 2: API MPMS Chapter 10.6 (Test Method
D1796) along with API
1.2 The values stated in SI units are to
be regarded as the standard. The values given in parentheses are
for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see 6.1. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
