Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Rubber Insulating Matting
Automaticky preložený názov:
Štandard Specification na gumu IZOLAČNÉ ROHOŽE
NORMA vydaná dňa 1.10.2010
Označenie normy: ASTM D178-01(2010)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2010
Kód tovaru: NS-18352
Počet strán: 9
Približná hmotnosť: 27 g (0.06 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
rubber insulating matting, ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
1. Scope | ||||||||||||||||||||||||||
1.1 This specification covers acceptance testing of rubber insulating matting for use as a floor covering for protection of workers. 1.2 Two types of matting, differing in chemical and physical characteristics, are provided and are designated as Type I and Type II matting. 1.3 The following safety hazards caveat applies only to the test method portion, Sections 17 to 19, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—Rubber insulating matting should remain flexible for use through normal temperature ranges. Note 2—Rubber as used in this specification is a generic term that includes elastomers and elastomer compounds, regardless of origin. X1.1.1 This test method covers a small-scale horizontal laboratory screening procedure for measuring the rate, extent, or time, or a combination thereof, of burning of rigid or flexible cellular plastics in accordance with this test procedure. X1.1.2 Materials that exhibit pronounced shrinking, curling, or melting away upon heating cannot be evaluated by this test method. X1.1.3 This test method is not applicable to materials that cannot be ignited under the conditions of this test, or to materials that exhibit progressive combustion without flame (continued glowing or charring). Note X1.1—The rate of burning or extent of burning of rigid cellular plastics also may be determined by Test Method D3014 where the specimen is supported vertically. X1.1.3.1 WarningDuring the course of combustion, gases or vapors, are evolved that may be hazardous to personnel. Adequate precautions should be taken to protect the operator. X1.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Historická
1.3.2014
Historická
1.8.2011
Historická
1.9.2013
Historická
1.11.2013
Historická
1.8.2011
Historická
1.8.2011
Posledná aktualizácia: 2024-11-21 (Počet položiek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.