Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D1636-21
Standard Specification for Allyl Molding Compounds
NORMA vydaná dňa 1.7.2021
Informácie o norme:
Označenie normy: ASTM D1636-21
Dátum vydania normy: 1.7.2021
Kód tovaru: NS-1031878
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D1636-21 :
This specification provides for the identification of three types of allyl molding compounds, based on the general type of filler employed in their manufacture: Type I - High-strength materials, glass-fiber reinforced; Type II - General-purpose mineral filled; and Type III - General-purpose synthetic fiber filler. Types I and II may be subdivided into four classes according to resin composition and use as follows: Class A - Diallyl ortho-phthalate resin, nonflame-retardant; Class B - Diallyl ortho-phthalate resin, flame-retardant; Class C - Diallyl meta-phthalate resin nonflame-retardant; and Class D - Diallyl meta-phthalate resin, flame-retardant. Materials shall be compression molded, conditioned, and tested; and the individual grades shall conform to specified values of impact resistance, flexural strength, permittivity and dissipation factor, insulation resistance, flame resistance, and oxygen index.
Keywords:
allyl, diallyl phthalate (DAP), molding compounds-thermosetting,, ICS Number Code 83.140.99 (Other rubber and plastic products)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||
|
1.1?This specification covers compression molding, thermosetting, allyl compounds as further defined in Section 4. 1.2?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. Note 1:?The properties included in this specification are
those required to identify the molding compounds covered. There may
be other requirements necessary to identify particular
characteristics. These will be added to the specification as their
inclusion becomes generally desirable and the necessary test data
and methods become available.
Note 2:?There is no known ISO equivalent to this
standard.
1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
