Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D1425-96
Standard Test Method for Unevenness of Textile Strands Using Capacitance Testing Equipment (Withdrawn 2005)
Automaticky preložený názov:
Štandardná skúšobná metóda pre nerovnosti textilných pradivá Použitie Kapacitné zariadení skúšobný ( Withdrawn 2005 )
NORMA vydaná dňa 10.2.1996
Informácie o norme:
Označenie normy: ASTM D1425-96
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.2.1996
Kód tovaru: NS-17247
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Doplňujúce informácie
| 1. Scope |
|
1.1 This test method covers the indirect measuring of unevenness of textile strands from tow, top, sliver, roving, and yarn produced from staple fibers and filament yarns by means of continuous runs using capacitance testing equipment. 1.2 The test method provides a value of "short-term unevenness," a single value expressing the complicated strand property that is unevenness. 1.3 The test method is applicable to all yarns, rovings, slivers, and tops, except as indicated below. 1.3.1 Low twist filament yarns should be tested only if additional twist is inserted during testing. Note 1-In many cases, these low twist yarns tend to flatten to a ribbon while passing through the condenser of the instrument, and the recorded value of unevenness is increased above the true value.1.3.2 Strands made from fiber blends should be tested only if blending is uniform along the strand. Note 2-Nonuniform blending may cause a higher reading of unevenness than the true value if the component fibers differ in dielectric constant. The magnitude of the increase of unevenness readings due to nonuniform blending cannot be stated in general terms.1.4 The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Odporúčame:
EviZak - všetky zákony vrátane ich evidencie na jednom mieste
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
