Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Evaluating Rubber Property´Retraction at Lower Temperatures (TR Test)
Automaticky preložený názov:
Štandardná skúšobná metóda pre hodnotenie gumové Property'Retraction pri nižších teplotách (TR Test)
NORMA vydaná dňa 1.7.2008
Označenie normy: ASTM D1329-08
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.7.2008
Kód tovaru: NS-16997
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
crystallization, low temperature retraction, rubber, temperature retraction, testing at subnormal temperatures, TR test, viscoelastic properties, Crystallization, Low-temperature testing--rubber, Retraction, Rubber property analysis, Temperature-retraction procedure, Temperature tests--rubber, TR test, Viscoelastic properties, ICS Number Code 83.060 (Rubber)
Significance and Use | ||||
The difference between the temperature at which a vulcanizate retracts 10 % (TR10) and the temperature at which a vulcanizate retracts 70 % (TR70) increases as the tendency to crystallize increases. TR70 correlates with low-temperature compression set. TR10 has been found to correlate with brittle points in vulcanizates based on polymers of similar type. In general, the retraction rate is believed to correlate with low-temperature flexibility of both crystallizable and noncrystallizable rubbers. |
||||
1. Scope | ||||
1.1 This test method describes a temperature-retraction procedure for rapid evaluation of crystallization effects and for comparing viscoelastic properties of rubber and rubber-like materials at low temperatures. This test method is useful when employed in conjunction with other low-temperature tests for selection of materials suitable for low-temperature service. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.5.2008
Historická
1.10.2010
Historická
1.12.2012
Historická
1.11.2013
Historická
1.1.2012
Historická
1.6.2010
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.