Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D1316-93(2001)
Standard Test Method for Fineness of Grind of Printing Inks By the NPIRI Grindometer
Automaticky preložený názov:
Štandardná skúšobná metóda pre Jemnosť Grind tlačiarenských farieb U NPIRI Grindometer
NORMA vydaná dňa 15.10.1993
Informácie o norme:
Označenie normy: ASTM D1316-93(2001)
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.10.1993
Kód tovaru: NS-16961
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM D1316-93(2001) :
Keywords:
degree of dispersion, grind gage, NPIRI Grindometer, pigment dispersions, printing inks, ICS Number Code 87.080 (Inks. Printing inks)
Doplňujúce informácie
| 1. Scope | ||||||||||||
|
1.1 This test method describes the procedure for determining the fineness of grind of printing inks using a NPIRI grindometer. It evaluates the size of the largest particles in a finished dispersion but not average particle size or concentration of sizes. 1.2 This test method is applicable to any dispersion that is fine enough to fall within the 0-25 μm range of the specified grind gage. With a minor variation in procedure, it is applicable to both paste (nonvolatile) and liquid (volatile) inks. Note 1—The 0-25 μm gage specified in this test method is similar in principle to the 0-100 μm Hegman gage described in Test Method D 1210. Sieve analysis for concentration of particles above 45 μm is covered in Test Method D 2067. <>1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
| 2. Referenced Documents | ||||||||||||
|
Doporučujeme:
