Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D1203-21
Standard Test Methods for Volatile Loss from Plastics Using Activated Carbon Methods
NORMA vydaná dňa 1.5.2021
Informácie o norme:
Označenie normy: ASTM D1203-21
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2021
Kód tovaru: NS-1024812
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D1203-21 :
Keywords:
plasticizer loss, vinyl, volatile loss, volatility, weight loss,, ICS Number Code 83.080.01 (Plastics in general)
Doplňujúce informácie
| Significance and Use | ||||||||||
|
4.1?The test methods are intended to be rapid empirical tests which have been found to be useful in the relative comparison of materials having the same nominal thickness. Note 2:?When the plastic material contains plasticizer, loss
from the plastic is assumed to be primarily plasticizer. The effect
of moisture is considered to be negligible.
4.2?Correlation with ultimate application for various plastic materials shall be determined by the user. |
||||||||||
| 1. Scope | ||||||||||
|
1.1?These test methods cover the determination of volatile loss from a plastic material under defined conditions of time and temperature, using activated carbon as the immersion medium. 1.2?Two test methods are covered as follows: 1.2.1?Test Method A, Direct Contact with Activated CarbonIn this test method the plastic material is in direct contact with the carbon. This test method is particularly useful in the rapid comparison of a large number of plastic specimens. 1.2.2?Test Method B, Wire CageThis test method prescribes the use of a wire cage, which prevents direct contact between the plastic material and the carbon. By eliminating the direct contact, the migration of the volatile components to the surrounding carbon is minimized and loss by volatilization is more specifically measured. 1.3?The values stated in SI units are to be regarded as the standard. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1:?This standard and ISO 176 address the same subject
matter, but differ in technical content.
1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
