Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practices for Resistance of Adhesives to Cyclic Laboratory Aging Conditions
Automaticky preložený názov:
Štandardné postupy pre odolnosť lepidiel na cyklické Laboratory starnutie podmienky
NORMA vydaná dňa 1.4.2011
Označenie normy: ASTM D1183-03(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2011
Kód tovaru: NS-16557
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
adhesives, humidity, laboratory aging, temperature, test conditions, Accelerated aging/testing--adhesives, Adhesives, Bond strength--adhesives, Cyclic exposure testing, Degradation--adhesives, Humidity, Laboratory aging/weathering, Strength--adhesives, Temperature tests--adhesives, ICS Number Code 83.180 (Adhesives)
Significance and Use | ||||||||||||||||||
This practice provides information on the resistance to cyclic laboratory aging. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 These practices cover the determination of the resistance of adhesives to cyclic accelerated service conditions by exposing bonded specimens to conditions of high and low temperatures and high and low relative humidities. The extent of degradation is determined from changes in strength properties as a result of exposure to the test conditions (Note 1). It is recognized that no accelerated procedure for degrading materials correlates perfectly with actual service conditions, and that no single or small group of laboratory test conditions will simulate all actual service conditions. Consequently, care must be exercised in the interpretation and use of data obtained in this practice. The test condition, the number of cycles of the test condition to be used, the particular strength property to be used to determine the extent of degradation, and whether test specimens or test panels are to be used, is specified in the material specification. Note 1—These practices/conditions are intended for use with specimens described in the approved ASTM strength test methods for adhesives as follows: Test Methods D897, D903, D906, D950, D1002, D1062, and Method . 1.2 The values stated in SI units are to be regarded as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Historická
1.10.2013
Historická
1.10.2013
Historická
1.11.2009
Historická
1.10.2010
Historická
1.11.2012
Historická
1.5.2011
Posledná aktualizácia: 2024-11-29 (Počet položiek: 2 209 787)
© Copyright 2024 NORMSERVIS s.r.o.