Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Viscosity of Adhesives
Automaticky preložený názov:
Štandardné skúšobné metódy pre Viskozita lepidiel
NORMA vydaná dňa 1.2.2008
Označenie normy: ASTM D1084-08
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.2.2008
Kód tovaru: NS-16281
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
adhesive, viscosity, Brookfield viscometer, Rubber adhesives, Viscometers--Stormer, Viscometers--Zahn, Viscosity--adhesives, ICS Number Code 83.180 (Adhesives)
Significance and Use | ||||||||||||||||||
Several test methods are noted for viscosity determination of Newtonian and near Newtonian flow characteristics. (For adhesives not fitting into this category, Test Method D 2556 should be considered.) Four test methods are covered as follows: Method A is applicable only to adhesives that will deliver 50 mL in a steady uninterrupted stream from one of the cups described in Section 5. Method B is intended for measuring the
viscosity of adhesives covering a range from 0.05 Pa · s to 200 Pa · s Method C is intended primarily as a control method for determining the viscosity of adhesives that have or approach Newtonian flow characteristics. Method D is intended primarily as a control method for determining the viscosity of materials that have an equivalent viscosity no greater than approximately 3000 cP and is limited to materials that have or approach Newtonian flow characteristics. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 These test methods cover the determination of the viscosity of free-flowing adhesives. 1.1.1 The limitation of this test method to self-leveling adhesives eliminates thixotropic and plastic materials whose viscosity is a function of the rate of stirring and previous history of the adhesive. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Historická
1.11.2012
Historická
1.5.2011
Historická
1.9.2011
Historická
1.10.2013
Historická
1.4.2008
Historická
1.6.2010
Posledná aktualizácia: 2024-11-29 (Počet položiek: 2 209 787)
© Copyright 2024 NORMSERVIS s.r.o.