Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM D1000-17
Standard Test Methods for Pressure-Sensitive Adhesive-Coated Tapes Used for Electrical and Electronic Applications
NORMA vydaná dňa 1.7.2017
Informácie o norme:
Označenie normy: ASTM D1000-17
Dátum vydania normy: 1.7.2017
Kód tovaru: NS-688314
Počet strán: 20
Približná hmotnosť: 60 g (0.13 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM D1000-17 :
Keywords:
accelerated aging, adhesion, adhesive, backing, bond strength, breaking strength, conditioning, dielectric breakdown, electrical insulating tape, elongation, flagging, flammability, high temperature testing, insulation resistance, length, low temperature testing, oil resistance, pressure-sensitive adhesive tape, puncture resistance, thermosetting, thickness, unwind force, voltage, width ,, ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 These test methods cover procedures for testing pressure-sensitive adhesive-coated tapes to be used as electrical insulation. These tapes are classified as follows: 1.1.1 Class 1—Non-elastomeric backings made from materials such as:
1.1.2 Class 2—Elastomeric backings that are characterized by both high stretch and substantial recovery. These backings are made from materials such as:
1.2 Test laminates of Class 1 and Class 2 backings according to Class 1 test methods. 1.3 The procedures appear in the sections indicated below and in alphabetical order:
Note 1: These procedures apply to both Class 1 and Class 2
tapes except as noted above.
1.4 This is a fire-test response standard (see Section 104). 1.5 The values stated in SI units are the standard, unless otherwise noted. If a value for measurement is followed by a value in inch-pound or English units in parentheses, it is likely that the second value will only be approximate and it is for information only. The first stated value is the preferred unit. Note 2: These test methods are similar to IEC 60454–3, but may
differ sometimes in some details.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards see Section 3. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
