Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Inner and Outer Diameters of Thermal Insulation for Nominal Sizes of Pipe and Tubing
NORMA vydaná dňa 1.5.2022
Označenie normy: ASTM C585-22
Dátum vydania normy: 1.5.2022
Kód tovaru: NS-1064841
Počet strán: 10
Približná hmotnosť: 30 g (0.07 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
pipe thermal insulation diameter, pipe thermal insulation dimension, pipe thermal insulation dimensional tolerance, thermal insulating materials-pipe, thermal insulating materials-tubing, thermal insulation, tubing thermal insulation diameter, tubing thermal insulation dimension, tubing thermal insulation dimensional tolerance,, ICS Number Code 27.220 (Heat recovery. Thermal insulation)
Significance and Use | ||||
4.1?The purpose of this practice is to ensure satisfactory fit on standard sizes, to accommodate radial expansion of pipes and tubes which are heated after being insulated, and to minimize the number of insulation sizes and thicknesses to be manufactured and stocked. 4.2?While it is possible to manufacturer insulation to these recommended dimensions, exercise care in attempting to nest layers of different materials, or layers supplied by different manufacturers. Individual manufacturing processes will operate at slightly different tolerances. While the product will fit the pipe, it is possible that it will not readily nest as the outer layer between the different materials, or with a different manufacturer, and possibly the same manufacturer. Exercise care to determine these differences before specifying or ordering nesting sizes. 4.3?The wide range of outer diameter dimensional tolerances will prevent many pipe and tube insulations from nesting for staggered joints or double layered applications, or both unless specified when ordered from the manufacturer, distributor, or fabricator. 4.4?Dimensions in accordance with this practice do not necessarily permit application of one thickness of pipe insulation over another (Nesting or Simplified Dimensional System) to obtain total thicknesses greater than those manufactured as single layer, or for multilayer application when desired. FIG. 3?Hinged Section Measurement Location |
||||
1. Scope | ||||
1.1?This practice is intended as a dimensional standard for preformed thermal insulation for pipes and tubing. 1.2?This practice covers insulation supplied in cylindrical sections and lists recommended single layer inner and outer diameters of insulation having nominal wall thicknesses from 1/2?to 5 in. (13 to 127 mm) to fit over standard sizes of pipe and tubing. 1.3?The values stated in inch-pound units are to be regarded as the standard. The values stated in SI units are provided for information only. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.