Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Dimensions and Density of Preformed Block and Board-Type Thermal Insulation
Automaticky preložený názov:
Štandardná skúšobná metóda pre Rozmery a hustota vopred pripraveného bloku a doskové tepelnou izoláciou
NORMA vydaná dňa 1.6.2010
Označenie normy: ASTM C303-10
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2010
Kód tovaru: NS-12876
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
block, board, density, dimensions , thermal insulation, thermal insulating materials-block and board, Block and board thermal insulation, Density--thermal insulating materials, Dimensions, Preformed thermal insulation, ICS Number Code 91.100.60 (Thermal and sound insulating materials)
Significance and Use | ||||||||
Dimensional measurements of the product thermal insulation are essential in determining compliance of a product with specification limits. Dimensional measurements of various test specimens are also required by the specific test method. Density measurements of the product insulation are useful in determining compliance of a product with specification limits, and in providing a relative gage of product weights. For any one kind of insulation, some important physical and mechanical properties, such as thermal conductivity, heat capacity, strength, etc., bear a specific relationship with its density. In order to design for equipment supports, check the material for the “as received density” where the moisture content of the product as received and then installed may consequential. |
||||||||
1. Scope | ||||||||
1.1 This test method covers determination of the dimensions and density of block and board insulation as defined in Terminology C168. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.3.2012
Historická
1.9.2012
Historická
1.9.2012
Historická
1.10.2010
Historická
1.11.2013
Historická
1.11.2013
Posledná aktualizácia: 2024-11-04 (Počet položiek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.