Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM C279-13
Standard Specification for Chemical-Resistant Masonry Units
Automaticky preložený názov:
Štandardné špecifikácie pre chemické odolné murárske jednotky
NORMA vydaná dňa 1.6.2013
Informácie o norme:
Označenie normy: ASTM C279-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2013
Kód tovaru: NS-12796
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM C279-13 :
Keywords:
absorption, acid resistance, acid solubility, ceramic, chemical-resistant, masonry, physical properties, solid brick, ICS Number Code 91.100.15 (Mineral materials and products)
Doplňujúce informácie
| Significance and Use | ||||||||
|
5.1 The brick and tile covered herein are intended essentially for use in chemical environments where resistance to thermal shock may or may not be a consideration. The brick and tile are normally used with chemical-resistant mortars. |
||||||||
| 1. Scope | ||||||||
|
1.1 This specification covers solid, kiln fired brick and tile made from clay, shale, or mixtures thereof, suitable for indoor and outdoor use in masonry construction subjected to chemical environments (see Terminology C1232). 1.2 The physical and chemical properties of brick and tile differ from supplier to supplier, mainly because their composition is determined by the source of raw materials. Regardless of the differences, brick and tile are considered to be one of three types and one of two classes as follows: 1.2.1 Type I—For use where low absorption and high acid resistance are not major factors. 1.2.2 Type II—For use where lower absorption and higher acid resistance are required. 1.2.3 Type III—For use where minimum absorption and maximum acid resistance are required. 1.2.4 Class S—For use in
standard applications.
1.2.5 Class X—For use where a higher degree of precision and lower permissible variation in size than that permitted for Class S is required. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
| 2. Referenced Documents | ||||||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
