Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM C192/C192M-19
Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory
NORMA vydaná dňa 1.12.2019
Informácie o norme:
Označenie normy: ASTM C192/C192M-19
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2019
Kód tovaru: NS-983921
Počet strán: 8
Približná hmotnosť: 24 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM C192/C192M-19 :
Keywords:
concrete, cylinders, laboratory, prisms, strength testing ,, ICS Number Code 91.100.30 (Concrete and concrete products)
Doplňujúce informácie
| Significance and Use | ||||||||||||||||||||||||||||||||||||
|
4.1 This practice provides standardized requirements for preparation of materials, mixing concrete, and making and curing concrete test specimens under laboratory conditions. 4.2 If specimen preparation is controlled as stipulated herein, the specimens may be used to develop information for the following purposes: 4.2.1 Mixture proportioning for project concrete, 4.2.2 Evaluation of different mixtures and materials, 4.2.3 Correlation with nondestructive tests, and 4.2.4 Providing specimens for research purposes. Note 1: The concrete test results for concrete specimens made
and cured using this practice are widely used. They may be the
basis for acceptance testing for project concrete, research
evaluations, and other studies. Careful and knowledgeable handling
of materials, mixing concrete, molding test specimens, and curing
test specimens is necessary. Many laboratories performing this
important work are independently inspected or accredited. Practice
C1077 identifies and defines
the duties, responsibilities, and minimum technical qualification
requirements of laboratory personnel and the minimum requirements
for equipment used in testing concrete and concrete
aggregates.
|
||||||||||||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 This practice covers procedures for making and curing test specimens of concrete in the laboratory under accurate control of materials and test conditions using concrete that can be consolidated by rodding or vibration as described herein. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
Odporúčame:
Aktualizácia zákonov
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
