Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determination of Loose and Tapped Bulk Density of Plutonium Oxide
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie Loose a sypnej hmotnosti plutónia Oxide
NORMA vydaná dňa 1.1.2013
Označenie normy: ASTM C1770-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2013
Kód tovaru: NS-12394
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
apparent density, nuclear materials, packed density, powder metallurgy, ICS Number Code 27.120.30 (Fissile materials and nuclear fuel technology)
Significance and Use | ||||||||||||||
5.1 This test method is intended for determination of bulk loose or tapped density or both for plutonium oxide or similar metallic powders or compounds in the nuclear industry. It is intended for use when the quantity of available material for performing the measurements is limited because of reasons such as nuclear safety or laboratory scale limits on nuclear inventory. 5.2 Values of loose bulk density obtained using this test method should be used with caution since they can vary considerably depending on the initial state of dispersion of the test specimen, height-to-diameter ratio of the specimen in the graduated cylinder, the dryness of the powder, and other factors. 5.3 The data from the tapped bulk density test can be used to estimate the needed volume of small containers holding a fixed mass of powder that has been compacted. 5.4 This test method may be useful for the determination of the Carr Compressibility Index as described in Test Method D6393. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method specifies a method for the determination of loose and tapped bulk density of plutonium oxide powder. 1.2 This test method is applicable when limited quantities of powder are available for performance of the measurements. Alternative test methods, such as Test Methods B527 or D7481, may be used when sufficient quantities are available. 1.3 This test method contains notes that are explanatory and are not part of the mandatory requirements of the method. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historická
1.6.2011
Historická
1.1.2012
Historická
1.12.2008
Historická
1.6.2011
Historická
1.6.2009
Historická
1.6.2012
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.