Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Guide for Comparing Sealant Behavior to Reference Photographs
Automaticky preložený názov:
Štandardné Guide pre porovnávanie tesniaci materiál správanie na Referenčné Fotografie
NORMA vydaná dňa 1.1.2014
Označenie normy: ASTM C1756-14
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2014
Kód tovaru: NS-12368
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
adhesion failure, chalking, cohesion failure, crazed, dirt pick-up, elastomeric joint sealant, fluid migration, reversion, rundown, sag, ICS Number Code 91.100.50 (Binders. Sealing materials)
Significance and Use | ||
4.1 This guide is intended to be used in evaluating sealant conditions that occur in service, along with other diagnostic techniques in failure analysis. These standard reference photographs have been selected and approved through ASTM's consensus balloting process to illustrate terms defined by Committee C24. 4.2 Not all of the terms illustrated here are failures, and there are other failure mechanisms that affect sealants that are not discussed in this guide. This guide is intended to be one of a number of sources of information used in the evaluation of sealant behavior. |
||
1. Scope | ||
1.1 This guide provides photographs that illustrate sealant behavior terms that have been defined by Committee C24. 1.2 When available, photographs that better illustrate these terms, or that illustrate additional terms defined by Committee C24, will be included in future editions of this standard. Photographs for consideration may be submitted to the committee using the form in Appendix X1. 1.3 The committee with jurisdiction over this standard is not aware of any comparable standards published by other organizations. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Historická
1.6.2012
Historická
1.5.2011
Historická
1.6.2014
Historická
1.6.2012
Historická
1.6.2009
Historická
15.2.2011
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.