Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Measurement of Roll Wave Optical Distortion in Heat-Treated Flat Glass
Automaticky preložený názov:
Štandardná skúšobná metóda pre meranie Roll Wave Optické skreslenie v tepelne ošetreného Flat Glass
NORMA vydaná dňa 1.10.2011
Označenie normy: ASTM C1651-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2011
Kód tovaru: NS-12123
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
flat glass, heat-treated glass, optical distortion, roll wave, Flat glass, Heat-treated (HT) flat glass, Optical distortion/deviation, Roll wave, ICS Number Code 81.040.20 (Glass in building)
Significance and Use | ||||||
This test method is a procedure for determining the peak-to-valley depth and the wavelength of roll wave in flat glass and then calculating the optical distortion resulting from that roll wave. Peak-to-valley measurements provide a means of monitoring the roll wave distortion in a heat processed glass product. Measured peak-to-valley depth provides information required by some specifiers of heat-treated glass products. 5.3 Roll wave is inherent in flat glass which has been heat treated in a furnace in which rollers are used to convey the glass. 5.4 Consult Specifications C1036 and C1048 for additional glass characteristics and quality information. |
||||||
1. Scope | ||||||
1.1 This test method is applicable to the determination of the peak-to-valley depth and peak-to-peak distances of the out-of-plane deformation referred to as roll wave which occurs in flat, heat-treated architectural glass substrates processed in a heat processing continuous or oscillating conveyance oven. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This test method does not address other flatness issues like edge kink, ream, pocket distortion, bow, or other distortions outside of roll wave as defined in this test method. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.4.2012
Historická
1.4.2012
Historická
1.5.2013
Historická
1.6.2014
Historická
1.4.2012
Historická
1.5.2013
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.