Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Volume Shrinkage of Latex Sealants During Cure
Automaticky preložený názov:
Štandardná skúšobná metóda pre Volume zmršťovanie Latexové tmelov Počas vytvrdzovania
NORMA vydaná dňa 1.2.2014
Označenie normy: ASTM C1241-14
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.2.2014
Kód tovaru: NS-10211
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
latex sealant, sealant, shrinkage (volume), tooling, ICS Number Code 83.040.10 (Latex and raw rubber)
Significance and Use | ||||||
5.1 Shrinkage of a sealant, after application in a building joint, is caused by loss of volatile components from the sealant. This loss results in a decrease in volume and, hence, a change in the sealant's shape. This change in shape, in some applications, should be taken into consideration for acceptable joint appearance and geometry. 5.2 The shrinkage value obtained by this test method helps predict the appearance and geometry of the cured sealant in a building joint and is helpful in determining the amount and type of tooling to be done during installation of the sealant. 5.3 Latex sealants cure primarily through water evaporation. They may also contain small amounts of other volatile components. However, in this test method all volatiles are treated as water. This assumption still provides a meaningful shrinkage value since the small quantities of other volatiles and their differences in density from that of water do not significantly affect the usefulness of the result obtained. |
||||||
1. Scope | ||||||
1.1 This test method covers a laboratory procedure for determining volume shrinkage, which occurs during cure, of a latex sealant. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|
|
Standard Test Method for Density of Liquid Coatings, Inks, and Related Products
|
|
Standard Terminology of Building Seals and Sealants
|
ISO 10563
|
Building Construction-Sealants-Determination of Change in Mass and Volume |
Historická
1.11.2011
Historická
1.11.2011
Historická
1.11.2011
Historická
1.11.2011
Historická
1.6.2010
Historická
1.5.2011
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.