Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM C1214M-19
Standard Test Method for Concrete Pipe Sewerlines by Negative Air Pressure (Vacuum) Test Method (Metric)
NORMA vydaná dňa 1.1.2019
Informácie o norme:
Označenie normy: ASTM C1214M-19
Dátum vydania normy: 1.1.2019
Kód tovaru: NS-910530
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM C1214M-19 :
Keywords:
ICS Number Code 23.040.50 (Pipes and fittings of other materials)
Doplňujúce informácie
| Significance and Use | ||||||
|
5.1 This is not a routine test. The values recorded are applicable only to the sewer being tested and at the time of testing. |
||||||
| 1. Scope | ||||||
|
1.1 This test method covers procedures for testing concrete pipe sewerlines, when using the negative air pressure (vacuum) test method to demonstrate the integrity of the installed material and the construction procedures. This test method covers testing of 100 to 900-mm diameter circular concrete pipe sewerlines utilizing gasketed joints. Note 1: The user of this specification is advised that methods
described in this test method may also be used as a preliminary
test to enable the manufacturer or installer to demonstrate the
condition of sewer pipe prior to delivery or backfill. Minimum test
times presented in Table 1
are for pipelines. Holding times for testing an individual pipe may
have to be increased to allow for the accumulation of leakage when
the tested pipe are incorporated into a continuous
pipeline.
Note 2: The user of this test method is advised that the
negative air pressure (vacuum) test criteria presented in this test
method are similar to those in general use. The test and criteria
have been used widely and successfully in testing smaller diameter
pipe. Larger pipe will be accepted more conveniently by visual
inspection and individual joint testing.
Note 3: Test times tabulated and the rate of air loss in this
standard are based on successful testing of installed pipelines.
However, since air and water have different physical properties,
retests of some pipelines not meeting field air tests have been
successful when tested with water.
1.2 This test method is the SI companion to Test Method C1214. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
