Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM C1126-13a
Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation (Includes all amendments And changes 6/3/2014).
Automaticky preložený názov:
Štandardné špecifikácie pre pokryté alebo unfaced tuhého, z buniek fenolových Tepelná izolácia
NORMA vydaná dňa 1.11.2013
Informácie o norme:
Označenie normy: ASTM C1126-13a
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.11.2013
Kód tovaru: NS-9618
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM C1126-13a :
Keywords:
cellular phenolic thermal insulation, faced phenolic foam thermal insulation, phenolic foam thermal insulation, rigid thermal insulation, unfaced phenolic foam thermal insulation, ICS Number Code 83.100 (Cellular materials)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers faced or unfaced, rigid cellular phenolic thermal insulation. Boards shall be faced or unfaced. Tubular forms covered by this standard shall be unfaced. It does not apply to field expanded cellular phenolic materials. 1.2 Materials covered by this
specification are used as roof insulation; sheathing or rigid board
for non-load bearing, building material applications; and pipe
insulation for use between −40 and 257°F (−40 and 125°C). Type II
and Type III materials with an appropriate vapor retarder covering
on the warm surface are used to a lower temperature limit of −290°F
(−180°C). (See 1.3 The values stated in inch-pound
units are to be regarded as standard. The values given in
parentheses are mathematical conversions to SI units that are
provided for information only and are not considered standard.
1.4 This specification covers closed cell rigid cellular phenolic thermal insulation manufactured using blowing agents with an ozone depletion of 0 (ODP=0). 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 16. |
||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||
|
