Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Determining Compatibility of Liquid-Applied Sealants with Accessories Used in Structural Glazing Systems
Automaticky preložený názov:
Štandardná skúšobná metóda pre stanovenie Kompatibilita s tekutými zálievky s príslušenstvom použitých na konštrukčné systémy zasklenia
NORMA vydaná dňa 1.6.2011
Označenie normy: ASTM C1087-00(2011)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.6.2011
Kód tovaru: NS-9383
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
color change, compatibility, staining, structural glazing, structural sealant, ultra violet exposure, Visual examination--building materials, Adhesion--sealants, Adhesive bonds, Color--sealants, Compatibility--sealants, Exposure tests--ultraviolet, Gaskets, Heating tests--building products, Light exposure--sealants, Sealants, Shims, Spacers, Structural adhesives, Structural sealants, Ultraviolet (UV) analysis--sealants, ICS Number Code 91.100.50 (Binders. Sealing materials)
Significance and Use | ||
In structural sealant glazing systems, the sealant functions as the structural adhesive and may also function as the primary weather seal. As the structural adhesive, the integrity of the adhesive bond is critical. Changes in color and adhesion after exposure are two of the criteria that can be used to determine the compatibility of the system. Experience has shown that accessories that cause loss of adhesion or discoloration in this test method may also cause these occurrences in actual use. |
||
1. Scope | ||
1.1 This test method covers a laboratory screening procedure for determining the compatibility of liquid-applied structural sealant glazing sealants when in contact with accessories such as dry glazing gaskets, spacers, shims, and setting blocks after exposure to heat and ultraviolet light. 1.2 This test method includes the observation of three parameters as follows: 1.2.1 Changes in the color of the sealant, 1.2.2 Changes in the adhesion of the sealant to glass, and 1.2.3 Changes in the adhesion of the sealant to the accessory being tested. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—At this time, no comparable ISO standard exists. |
||
2. Referenced Documents | ||
|
Historická
1.6.2011
Historická
1.1.2011
Historická
1.1.2009
Historická
1.1.2014
Historická
1.7.2014
Historická
1.1.2009
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.