Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens
Automaticky preložený názov:
Štandardné praktiky pre lisovanie a sušenie ohňovzdorné plastickej a dusáním Mix vzoriek
NORMA vydaná dňa 1.4.2013
Označenie normy: ASTM C1054-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2013
Kód tovaru: NS-9217
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
drying, forming, pressing, refractory plastics, refractory ramming mixes, ICS Number Code 81.080 (Refractories)
Significance and Use | ||||||
3.1 This practice is useful for producing uniform specimens of refractory plastics and ramming mixes for use in standard ASTM tests. Samples thus formed may be used for referee testing when setting specifications between producer and user. Establish by mutual agreement and specify in the report the forming parameters such as sample size, workability, and forming pressure when referee testing. 3.2 This practice is applicable for preparing test specimens of various sizes. Note that 9 by 41/2 by 21/2 in. (228 by 114 by 64-mm) samples, because of their large cross-section, have a greater tendency to form flaws during pressing, handling, and drying than smaller cross-sectional samples. 3.3 The purpose of this practice is to minimize flaws in pressed specimens. It is not intended to duplicate all field installation conditions. 3.4 Variations in workability as determined by Test Method C181 can significantly affect the number of flaws contained in a specimen. Establish by mutual agreement the workability level when comparing tests between two laboratories. 3.5 This practice is not intended for preparing specimens of basic ramming mixes, anhydrous tap-hole mixes, nor resin bonded mixes. |
||||||
1. Scope | ||||||
1.1 This practice covers the pressing and drying of chemically and non-chemically bonded alumin-silicate and high alumina plastic and ramming mix refractory specimens classified in accordance with Classification C673. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.9.2009
Historická
1.9.2013
Historická
1.7.2011
Historická
1.9.2013
Historická
1.3.2012
Historická
1.9.2013
Poskytovanie aktuálnych informácií o legislatívnych predpisoch vyhlásených v Zbierke zákonov od roku 1945.
Aktualizácia 2x v mesiaci !
Chcete vedieť viac informácii ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-05-13 (Počet položiek: 2 898 634)
© Copyright 2024 NORMSERVIS s.r.o.