Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Flattening of Copper and Copper-Alloy Pipe and Tube
Automaticky preložený názov:
Štandardná skúšobná metóda pre zlúčenie z medi a zliatin medi Potrubné
NORMA vydaná dňa 1.4.2010
Označenie normy: ASTM B968/B968M-10
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.4.2010
Kód tovaru: NS-8956
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Copper, Copper Alloy, Flattening Test, Pipe, Tube, Copper, Copper alloy, Copper alloy pipe, Copper alloy tube, Flattening test, ICS Number Code 77.150.30 (Copper products)
Significance and Use | ||||
When properly performed and interpreted, the flattening test will provide information about the relative ductility of a tube and presence of surface defects. For welded tube products, the test will provide information on the integrity of the weld seam. In certain product specifications which establish requirements for tubes of sizes greater than 4 in. [100 mm], the test may be allowed as a substitute to the expansion pin test in B153. |
||||
1. Scope | ||||
1.1 This test method establishes the requirements for the flattening test for copper and copper alloy pipe and tube of all sizes. The method addresses both inch-pound and metric considerations, and both seamless and welded product. 1.2 Units—Values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.4.2009
Historická
1.10.2012
Historická
1.10.2012
Historická
1.4.2011
Historická
1.4.2014
Historická
1.10.2010
Posledná aktualizácia: 2024-11-03 (Počet položiek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.