Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Methods for Evaluating Connectability Characteristics of Electrical Conductor Materials
Automaticky preložený názov:
Štandardné testovacie metódy pre hodnotenie pripojiteľnosť Charakteristika elektrický vodič materiálov
NORMA vydaná dňa 1.10.2015
Označenie normy: ASTM B896-10(2015)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2015
Kód tovaru: NS-617113
Počet strán: 7
Približná hmotnosť: 21 g (0.05 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
connectability, contact resistance, creep, electrical conductor, fretting sensitivity, stress relaxation,, ICS Number Code 29.050 (Superconductivity and conducting materials)
Significance and Use | ||||
5.1 These test methods develop comparative information useful for the design of stationary contacts for wire, cable, and other conductors. 5.2 These test methods produce results, which are free of the influence of arbitrary connection systems. 5.3 The influence of conductor surface pretreatments and platings can be evaluated by these test methods. 5.4 The influence of environmental factors, such as high temperature and corrosive environment can be evaluated by these test methods. 5.5 The results obtained by these test methods provide guidance on connection system design parameters, such as contact force and gas tightness requirements. |
||||
1. Scope | ||||
1.1 These test methods define procedures for the relative characterization of conductor material connectability on the basis of measurements of parameters important to the design and performance of electrical contacts and connections to and with such conductors for both power and signal applications. 1.2 The parameters measured are contact resistance as a function of contact force, fretting sensitivity, and compressive relaxation. 1.3 Provision is made for measurement of the connectability parameters at elevated temperature, or corrosive ambient, or both, as may be required for evaluation for particular applications. 1.4 These test methods, using standardized specimen geometry and procedures, are applicable to conductor materials as employed in an electrical system and may be adapted for evaluation of connectability of materials in the form of actual connection system components. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.4.2013
Historická
1.5.2013
Historická
1.10.2013
Historická
1.5.2013
Historická
1.5.2004
Historická
1.6.2014
Posledná aktualizácia: 2024-05-01 (Počet položiek: 2 896 514)
© Copyright 2024 NORMSERVIS s.r.o.