Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Volumetric Flow Rate of Metal Powders Using the Arnold Meter and Hall Flowmeter Funnel
Automaticky preložený názov:
Štandardná skúšobná metóda pre objemový prietok Miera kovových práškov s použitím Arnold Meter a Hall Prietokomer Lievik
NORMA vydaná dňa 15.11.2011
Označenie normy: ASTM B855-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 15.11.2011
Kód tovaru: NS-8428
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
Arnold/Hall flow, interparticle friction, metal powders, volumetric flow rate, ICS Number Code 17.120.01 (Measurement of fluid flow in general)
Significance and Use | ||||||||||||
The volumetric flow rate is a measure of the flow characteristics of a metal powder. Measuring flow by volume as compared with flow per unit mass eliminates the variable of the powder density. The ability of a powder to flow and pack is a function of interparticle friction. As the surface area increases, the amount of friction in a powder mass also increases. Consequently, the friction between particles increases, giving less efficient flow and packing. Knowledge of the volumetric flow permits the number of parts that can be made per hour to be estimated. This test method may be part of the purchase agreement between powder manufacturers and powder metallurgy (P/M) part producers, or it can be an internal quality control test by either the producer or the end user. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers a procedure for measuring the flow characteristics of a given volume of powder. 1.2 The values stated in SI units are to be regarded as the standard (except for the Hall Flowmeter Funnel, which is produced in inch-pound units). The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historická
1.6.2011
Historická
1.6.2009
Historická
1.10.2011
Historická
1.2.2011
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.