Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Seamless Copper Tube for Natural Gas and Liquefied Petroleum (LP) Gas Fuel Distribution Systems
Automaticky preložený názov:
Štandardné špecifikácie pre bezšvové medené rúrky pre zemný plyn a skvapalnený ropný (LP) plynné palivá distribučných systémov
NORMA vydaná dňa 1.10.2010
Označenie normy: ASTM B837-10
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2010
Kód tovaru: NS-8345
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Zařízení pro dopravu a manipulaci ropných produktů a zemního plynu
Keywords:
brazed joints, C12200, flared fittings, fuel distribution systems, liquified petroleum (LP) gas, natural gas, seamless copper tube, UNS C12200--tube, Brazed joints, Flared fittings, Fuel distribution systems, Gas pressure systems/applications--specifications, GAS seamless copper UNS C12200 tube, LPG (liquefied petroleum gases)--specifications, Natural gas service systems--specifications, Seamless Cu/Cu alloy tube--specifications, UNS C12200--pipe/tube (seamless/welded)
Significance and Use | ||||||||||||||||||||||||
For purpose of determining compliance with the specified limits for requirements of the properties listed in Table 5, an observed value or calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29. |
||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||
1.1 This specification establishes the requirements for Type GAS seamless Copper UNS No. C12200 tube for use in above ground natural gas and liquified petroleum (LP) gas fuel distribution systems, commonly assembled with flared fittings or brazed joints. 1.2 O60 (soft annealed) temper gas tube is produced in the range of standard sizes 3/8– to 11/8–in. outside diameter; H58 (drawn general purpose) temper gas tube is produced in the range of standard sizes 3/8– to 11/8–in. outside diameter. Note 1—Tube temper, size and joining method are determined by installation code requirements. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. |
||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||
|
Historická
1.3.2010
Historická
1.5.2013
Historická
1.4.2012
Historická
1.3.2008
Historická
1.11.2012
Historická
1.11.2012
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.