Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Niobium-Hafnium Alloy Foil, Sheet, Strip, and Plate
NORMA vydaná dňa 1.10.2018
Označenie normy: ASTM B654/B654M-10(2018)
Dátum vydania normy: 1.10.2018
Kód tovaru: NS-900119
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
This specification covers foils, sheets, strips, and plates made from UNS R04295 hafnium alloyed niobium ingots and billets. The materials should be in the annealed condition unless otherwise specified. The materials may also be in a forged, rolled, extruded, swaged, or drawn finish in a cleaned, machined, or ground condition. All the products should be formed with conventional extrusion, forging, and rolling equipment normally used in metal working plants.
Keywords:
niobium-hafnium alloy foil, niobium-hafnium alloy plate, niobium-hafnium alloy sheet, niobium-hafnium alloy strip,, ICS Number Code 77.150.99 (Other products of non-ferrous metals)
1. Scope | ||||||||||
1.1 This specification covers hafnium alloyed niobium foil, sheet, strip, and plate. 1.2 The material covered by this specification is R04295, niobium-base alloy containing approximately 10 % hafnium and 1 % titanium. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 The following safety hazards caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Posledná aktualizácia: 2024-09-11 (Počet položiek: 2 346 290)
© Copyright 2024 NORMSERVIS s.r.o.