Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM B566-04a(2021)
Standard Specification for Copper-Clad Aluminum Wire (Includes all amendments and changes 10/22/2021).
NORMA vydaná dňa 1.10.2021
Informácie o norme:
Označenie normy: ASTM B566-04a(2021)
Dátum vydania normy: 1.10.2021
Kód tovaru: NS-1040589
Počet strán: 5
Približná hmotnosť: 15 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM B566-04a(2021) :
This specification covers bare round copper-clad aluminum wire for electrical applications. Four classes of copper-clad aluminum wire are covered such as Class 10A, Class 15A, Class 10H, Class 15H. The wire shall consist of a core of aluminum with a continuous outer cladding of copper throughly bonded to the core throughout and shall be of such quality as to meet the requirements of this specification. The copper-clad aluminum wire shall conform to the tensile strength and elongation requirements. The electrical resistivity shall be measured. The copper-clad aluminum wire, when tested shall be free from seams or splits. They shall be free from cladding delamination. The finished wire shall contain no joints or splices. The density of the wire shall be taken for calculating mass/unit length, cross section and so forth.
Keywords:
aluminum electrical conductor—copper-clad, aluminum wire, aluminum wire—copper-clad, copper-clad aluminum wire, copper-clad electrical conductors, electrical conductor,, ICS Number Code 29.060.10 (Wires)
Doplňujúce informácie
| 1. Scope | ||||||
|
1.1?This specification covers bare round copper-clad aluminum wire for electrical applications. 1.2?Four
classes of copper-clad aluminum wire are covered as follows: 1.3?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3.1?ExceptionThe values stated in SI units for resistivity and density are to be regarded as standard. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
