Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Bonded Copper Conductors for Use in Hookup Wires for Electronic Equipment
NORMA vydaná dňa 1.4.2017
Označenie normy: ASTM B470-02(2017)
Dátum vydania normy: 1.4.2017
Kód tovaru: NS-681008
Počet strán: 3
Približná hmotnosť: 9 g (0.02 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
This specification covers stranded uninsulated bare, tin, or tin-lead alloy coated copper conductors in which wires in the strand are metallically bonded together by the application of heat additional tin, or tin-lead alloy for use in hookup wire for electronic equipment. Conductor constructions shall conform to standard ASTM requirements except that, in addition, the following bondings may be specified: Type I, Type II, and Type III. The conductors shall consist of tinned copper and bare copper, conforming to product description, quality, and specification requirements. The material shall undergo flex, fraying, mandrel, and resistance tests. The material shall meet the minimum flex life requirements and shall conform to the required conditions for flex, fraying, and madrel tests.
Keywords:
bonded copper conductors, copper conductor for electronic equipment, copper electrical conductor, electrical conductor, electrical conductor´copper,, ICS Number Code 29.060.10 (Wires)
1. Scope | ||||
1.1 This specification covers stranded uninsulated bare, tin, or tin-lead alloy coated copper conductors in which wires in the strand are metallically bonded together by the application of heat or additional tin, or tin-lead alloy for use in hookup wire for electronic equipment. 1.2 The SI values for density and resistivity are to be regarded as standard. For all other properties, the inch-pound values are to be regarded as the standard and the SI units may be approximate. 1.3 The hazard caveat pertains only to Section 6 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Posledná aktualizácia: 2024-09-09 (Počet položiek: 2 346 212)
© Copyright 2024 NORMSERVIS s.r.o.