Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM B398/B398M-22
Standard Specification for Aluminum-Alloy 6201-T81 and 6201-T83 Wire for Electrical Purposes
NORMA vydaná dňa 1.12.2022
Informácie o norme:
Označenie normy: ASTM B398/B398M-22
Dátum vydania normy: 1.12.2022
Kód tovaru: NS-1100815
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM B398/B398M-22 :
This specification covers aluminum-alloy 6201-T81 round wire which are solution heat-treated, cold worked, and artificially aged for electrical purposes. The material shall conform to the chemical composition requirements. Tensile properties such as tensile strength and elongation and bending properties shall be determined via a tension test and bending test, respectively. The electrical resistivity and density of the wires shall be measured as well.
Keywords:
aluminum alloy 6201-T81 wire, aluminum alloy 6201-T83 wire, aluminum alloy wire, aluminum wire, electrical conductor-aluminum, electrical conductors,, ICS Number Code 29.060.10 (Wires)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||
|
1.1?This specification covers aluminum-alloy 6201-T81 (hard, solution heat-treated, cold worked, and artificially aged) and 6201-T83 (hard, higher conductivity, solution heat-treated, cold worked, and artificially aged) round wire for electrical purposes. Note 1:?The alloy and temper designations conform to ANSI
H35.1 and H35.1M. Aluminum-alloy 6201 corresponds to unified
numbering system alloy A96201 in accordance with Practice
E527.
1.2?The values stated in inch-pound or SI units are to be regarded separately as standard. The values in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.2.1?For density, resistivity and temperature, the values stated in SI units are to be regarded as standard. 1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
