Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Copper-Zinc-Silicon Alloy Rod
NORMA vydaná dňa 1.4.2019
Označenie normy: ASTM B371/B371M-19
Dátum vydania normy: 1.4.2019
Kód tovaru: NS-945890
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
This specification establishes the requirements for rods of copper-zinc-silicon alloy with Copper Alloy UNS Nos. C69300, C69400, C69430, C69700, and C69710. The materials for manufacture shall be cast billets, logs, or rods of such purity and soundness as to be suitable for processing by cold working, annealing, straightening, and cutting to length as may be necessary to produce finished products that meet the properties specified. Tempers available under this specification are H02 (half hard) for UNS No. C69300, and H04 (hard) for all other UNS Nos. Products shall be tested (including by residual stress test and ammonia vapor test) and shall adhere to dimensional (diameter, length, straightness, and edge contour), mechanical (tensile and yield strength, and elongation), and chemical composition requirements.
Keywords:
copper-zinc-silicon rod, UNS No. C69240, UNS No. C69300, UNS No. C69400, UNS No. C69410, UNS No. C69430, UNS No. C69700, UNS No. C69710, UNS No. C69850,, ICS Number Code 77.140.60 (Steel bars and rods)
1. Scope | ||||||||||||||
1.1 This specification establishes the requirements for copper-zinc-silicon alloy rod produced in Copper Alloy UNS Nos. C69240, C69300, C69400, C69410, C69430, C69700, C69710, and C69850. 1.1.1 If the purchaser does not specify the alloy to be supplied, product is permitted to be furnished in any of the alloys named in 1.1. 1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 The following safety hazard caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use. 1.4 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-22 (Počet položiek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.