Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
Automaticky preložený názov:
Štandardná skúšobná metóda pre expanziu (Pin Test) z medi a zliatin medi rúrky a rúrky
NORMA vydaná dňa 1.1.2011
Označenie normy: ASTM B153-11
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.1.2011
Kód tovaru: NS-5502
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
copper, copper alloy, expansion, expansion test, pin test, pipe, tube, Pin test, Copper alloy pipe, Copper alloy tube, Copper pipe, Copper tube, Expansion, ICS Number Code 23.040.15 (Non-ferrous metal pipes)
Significance and Use | ||||
When properly performed and interpreted, the expansion pin test will provide information with regard to the capacity of a tube for expansion and to reveal surface defects. The expansion pin test may provide data for research and development, engineering design, quality control, and acceptance or rejections in specifications. In certain product specifications which establish requirements for tubes of sizes greater than 4 in. (102 mm), the test described in B968/B968M may be allowed as a substitute. |
||||
1. Scope | ||||
1.1 This test method establishes the requirements for the expansion pin test for copper and copper-alloy pipe and tubing with an inside diameter of 0.125 in. (3.2 mm) and greater or an outside diameter up to and including 4 in. (102 mm). Note 1—For tubes of sizes with an inside diameter less than 0.125 in. (3.2 mm), a substitute test method must be agreed upon between the manufacturer and purchaser. Note 2—For tubes of sizes greater than 4 in. (102 mm) in outside diameter, refer to B968/B968M for a test method. 1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
15.4.2009
Historická
1.10.2010
Historická
1.10.2010
Historická
1.10.2011
Historická
1.12.2006
Historická
1.10.2009
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.