Pozor!

Vo Vašom prehliadači nie je aktuálne povolené spúšťanie Javascriptu. Je možné, že niektoré funkcie nebudú fungovať správne. Pre plnú funkčnosť internetového obchodu odporúčame povoliť Javascript. Tu sú inštrukcie ako povoliť JavaScript vo Vašom webovom prehliadači.

Zobrazovaná mena: €

Zobrazenie ceny: bez DPH

NEPLATNÁ ASTM A995/A995M-13 1.12.2013 náhľad

Doplňujúce informácie

ASTM A995/A995M-13

Standard Specification for Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for Pressure-Containing Parts

Automaticky preložený názov:

Štandard Specification na odliatky, austenitické-feritickej (duplex) nerezovej ocele, pre tlak, obsahujúce diely

NORMA vydaná dňa 1.12.2013

Jazyk
Prevedenie	PDF - okamžité stiahnutie - 70.30 € Tlačené - 70.30 €
Dostupnosť	SKLADOM
Cena	70.30 € bez DPH
70.30 €

Informácie o norme:

Označenie normy: ASTM A995/A995M-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2013
Kód tovaru: NS-5254
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM

Tlač

Odoslať známemu

Otázka

Kategórie - podobné normy:

Železné a ocelové odlitky

Anotácia textu normy ASTM A995/A995M-13 :

Keywords:

austenitic-ferritic, duplex stainless steel, pressure-containing, steel castings, ICS Number Code 77.140.80 (Iron and steel castings)

Doplňujúce informácie

1. Scope

1.1 This specification covers austenitic-ferritic (duplex) stainless steel castings for valves, flanges, fittings, and other pressure-containing parts.

1.2 The duplex stainless steels offer a combination of enhanced mechanical properties and corrosion resistance when properly balanced in composition and properly heat treated. Ferrite levels are not specified, but these grades will develop a range of approximately 30 to 60 % ferrite with the balance austenite. It is the responsibility of the purchaser to determine which grade shall be furnished depending on design and service conditions, mechanical properties, and corrosion-resistant characteristics.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

2. Referenced Documents

E562-19e1	Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count (Includes all amendments and changes 8/24/2020).
A488/A488M-18e2	Standard Practice for Steel Castings, Welding, Qualifications of Procedures and Personnel (Includes all amendments and changes 2/12/2020).
E165-09	Standard Practice for Liquid Penetrant Examination for General Industry
E125-63(2023)	Standard Reference Photographs for Magnetic Particle Indications on Ferrous Castings
A703/A703M-20a	Standard Specification for Steel Castings, General Requirements, for Pressure-Containing Parts (Includes all amendments and changes 11/16/2020).