Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Wrought Nickel-Iron Soft Magnetic Alloys (UNS K94490, K94840, N14076, N14080)
NORMA vydaná dňa 1.2.2021
Označenie normy: ASTM A753-21
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.2.2021
Kód tovaru: NS-1018204
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
bars, billet, nickel-iron, permeability, plates, sheets, strips, wires,, ICS Number Code 77.120.40 (Nickel, chromium and their alloys)
| 1. Scope | ||||||||||||||||||||||
|
1.1This specification covers commonly used wrought nickel-iron soft magnetic alloys produced or supplied expressly for use in magnetic cores and other parts requiring high magnetic permeability, high electrical resistivity, low coercive field strength, and low core loss. 1.2This specification covers materials supplied by a producer or converter to the form and physical condition desired for fabrication into parts that will later be given a final heat treatment to achieve the desired magnetic characteristics. It covers materials supplied in the form of forging billet; hot-rolled plate, strip, and bar; cold-finished bar; cold-rolled and annealed sheet and strip; shaped bar and wire; and wire. 1.2.1This specification does not cover either powder metallurgically produced or cast parts. 1.2.2This specification lists requirements for strip products having isotropic or semi-isotropic magnetic properties but does not include requirements for anisotropic or square hysteresis loop alloys or alloys processed to yield flattened hysteresis loops by use of heat treatments in an applied magnetic field. 1.2.3This specification does not cover alloys modified by the addition of elements such as sulfur and selenium to enhance machinability. 1.3The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to customary (cgs-emu and inch-pound) units which are provided for information only and are not considered standard. 1.3.1There are selected values presented in two units, both of which are in acceptable SI units. These are differentiated by the word , or, as in g/cm3, or, (kg/m3). In addition, values for mean linear coefficient of expansion in Table X1.1 are shown solely in m/m/C in keeping with prior versions of this standard. 1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||
|
Posledná aktualizácia: 2026-11-19 (Počet položiek: 2 211 086)
© Copyright 2026 NORMSERVIS s.r.o.