Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A727/A727M-13
Standard Specification for Carbon Steel Forgings for Piping Components with Inherent Notch Toughness
Automaticky preložený názov:
Štandardné špecifikácie pre Carbon Oceľové výkovky pre potrubné diely s neoddeliteľná vrubová húževnatosť
NORMA vydaná dňa 1.10.2013
Informácie o norme:
Označenie normy: ASTM A727/A727M-13
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2013
Kód tovaru: NS-3900
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM A727/A727M-13 :
Keywords:
carbon equivalent, pipe fittings, steel, piping applications, pressure containing parts, steel flanges, steel forgings, carbon, steel valves, temperature service applications, low, ICS Number Code 77.140.85 (Iron and steel forgings)
Doplňujúce informácie
| 1. Scope | ||||||||
|
1.1 This specification2 covers forged carbon steel piping components intended primarily for service in pressure piping systems from −20 to +650 °F [−30 to +345 °C] where inherent notch toughness is desired, but where notch toughness testing is not required. Included are forged or ring-rolled flanges, forged fittings, and valves made to specified dimensions, or to dimensional standards such as the ASME and API specifications referenced in Section 2. 1.2 This specification is limited to forgings with maximum finished section thicknesses no larger than 2 in. [51 mm]. 1.3 It shall be the responsibility of the purchaser to determine whether material meeting the requirements of this specification is satisfactory for the service application. 1.4 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified by the purchaser in the order. 1.5 This specification is expressed
in both inch-pound units and in SI units. However, unless the order
specifies the applicable “M” specification designation (SI units),
the material shall be furnished to inch-pound units.
1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||
| 2. Referenced Documents | ||||||||
|
Odporúčame:
Aktualizácia technických noriem
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
