Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A610-79(2014)
Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size
Automaticky preložený názov:
Štandardné skúšobné metódy pre odber vzoriek a testovanie ferozliatiny pre stanovenie veľkosti
NORMA vydaná dňa 1.10.2014
Informácie o norme:
Označenie normy: ASTM A610-79(2014)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.10.2014
Kód tovaru: NS-3354
Počet strán: 2
Približná hmotnosť: 6 g (0.01 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Kategórie - podobné normy:
Anotácia textu normy ASTM A610-79(2014) :
Keywords:
crushed, ferroalloys, lump, plates, sampling, sieving, size, sizing, ICS Number Code 77.100 (Ferroalloys)
Doplňujúce informácie
| 1. Scope | ||||
|
1.1 These test methods cover procedures for the sampling and testing of the various ferroalloys for sizing, either before or after shipment from the plants of the manufacturers. 1.2 They are designed to give results representative of each lot that will be comparable with the manufacturer's certified analysis for the same lot. 1.3 The purchaser may use any sampling procedure he desires, but the results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these test methods. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4.1 Exception—The SI units that correspond to mesh sizes in Table 1 are to be regarded as standard. 1.5 This standard does not purport to
address all of the safety concerns, if any, associated with its
use. It is the responsibility of the user of this standard to
establish appropriate safety and health practices and determine the
applicability of regulatory limitations prior to use.
|
||||
| 2. Referenced Documents | ||||
|
Doporučujeme:
