Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Practice for Macroetch Testing of Consumable Electrode Remelted Steel Bars and Billets
Automaticky preložený názov:
Štandardné praktiky pre Macroetch testovanie elektródou pretavený oceľových tyčí a kláty
NORMA vydaná dňa 1.5.2012
Označenie normy: ASTM A604/A604M-07(2012)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2012
Kód tovaru: NS-3333
Počet strán: 14
Približná hmotnosť: 42 g (0.09 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
consumable electrode remelting, electroslag remelting, freckles, macro etching, radial segregation, ring pattern, segregation, vacuum arc remelting, white spots, Alloy steel bars, Electrochemical measurements/testing, Electrode remelted steel, Macroetching, Stainless steel bars/billets, Steel bars, Steel bars and billets, ICS Number Code 77.140.60 (Steel bars and rods)
Significance and Use | ||||
Macroetch testing, as described herein, is a method for examining and rating transverse sections of bars and billets to describe certain conditions of macro segregation which are often characteristic of consumable electrode remelted materials. This practice is not intended to define major defects such as those described by Method E381. |
||||
1. Scope | ||||
1.1 This practice covers testing and inspection and is applicable to bars, billets, and blooms of carbon, alloy, and stainless steel which have been consumable electrode remelted. 1.2 For the purpose of this practice, the consumable electrode remelting process is defined as a steel refining method wherein single or multiple electrodes are remelted into a crucible producing an ingot which is superior to the original electrode by virtue of improved cleanliness or lower gas content or reduced chemical or nonmetallic segregation. See Appendix X1 and Appendix X2 for descriptions of applicable remelting processes. 1.3 This practice and the accompanying comparison macrographs are generally applicable to steel bar and billet sizes up to 225 in.2 [1450 cm2] in transverse cross section. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.5.2014
Historická
1.7.2011
Historická
1.4.2010
Historická
1.5.2012
Historická
1.5.2014
Historická
1.3.2012
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.