Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Alloy and Structural Alloy Steel, Sheet and Strip, Hot-Rolled and Cold-Rolled
Automaticky preložený názov:
Štandardné špecifikácie pre zliatiny a štrukturálne legovanej ocele, plechy a pásy, valcované za tepla a za studena valcované
NORMA vydaná dňa 1.5.2012
Označenie normy: ASTM A506-12
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.5.2012
Kód tovaru: NS-2871
Počet strán: 4
Približná hmotnosť: 12 g (0.03 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
alloy steel sheet, alloy steel strip, cold-rolled alloy steel, hot-rolled alloy steel, standard alloy steel, structural alloy steel, Alloy steel sheet/strip--specifications, Cold-rolled steel sheet/strip--specifications, Hot-rolled steel sheet/strip--specifications, Structural steel (SS) sheet/strip--specifications, ICS Number Code 77.140.50 (Flat steel products and semi-products)
1. Scope | ||||
1.1 This specification covers hot-rolled and cold-rolled alloy and structural alloy-steel sheet and strip. Alloy steel is furnished to chemical composition requirements and is intended primarily for general or miscellaneous use where bending and moderate forming is a requirement. Structural alloy steel is furnished to chemical composition requirements and to specific mechanical property requirements which may include tension tests, hardness tests, or other commonly accepted mechanical tests. 1.2 If material of a higher degree of uniformity of internal soundness and freedom from surface imperfections is required, reference should be made to Specification A507. 1.3 Alloy and structural alloy-steel sheet and strip are not produced to internal cleanliness requirements. Normally surface imperfections are not objectionable, and a good finish is not a prime requirement. 1.4 The formability of structural alloy steel decreases with increasing yield strength or hardness. Therefore, product design in relation to the mechanical properties of the grade used must be considered. 1.5 The material covered by this specification may be furnished in several conditions: heat treatments, surface conditions, and edges, as specified herein, in coils or cut lengths. 1.6 The values stated in inch-pound units are to be regarded as the standard. SI units are provided for information only. |
||||
2. Referenced Documents | ||||
|
Historická
1.11.2010
Historická
1.5.2012
Historická
1.5.2013
Historická
1.10.2011
Historická
1.10.2011
Historická
1.4.2013
Chcete mať istotu, že používate len platné technické normy?
Ponúkame Vám riešenie, ktoré Vám zaistí mesačný prehľad o aktuálnosti noriem, ktoré používate.
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-12-23 (Počet položiek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.