Cookies
Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
ASTM A449-00
Standard Specification for Quenched and Tempered Steel Bolts and Studs
Automaticky preložený názov:
Štandardné špecifikácie pre rozloží a kalenej ocele skrutiek a svorníkov
NORMA vydaná dňa 10.5.2000
Informácie o norme:
Označenie normy: ASTM A449-00
Poznámka: NEPLATNÁ
Dátum vydania normy: 10.5.2000
Kód tovaru: NS-2510
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Anotácia textu normy ASTM A449-00 :
Keywords:
Carbon steel, Steel bolting materials-bolts, Steel bolting materials-studs, quenched and tempered carbon steel bolts/studs, spec, ICS Number Code 21.060.10 (Bolts, screws, studs)
Doplňujúce informácie
| 1. Scope | ||||||||||||||||||||
|
1.1 This specification covers the chemical and mechanical requirements for two types of quenched and tempered steel bolts and studs for general applications where high strength is required. 1.2 The two types of bolts covered in this specification are: 1.2.1 Type 1 -Medium-carbon steel bolts and studs furnished in nominal diameters of 1/4 to 3 in., inclusive. 1.2.2 Type 2 -Low-carbon martensite or medium-carbon martensite steel bolts and studs furnished in nominal diameters of 1/4 to 1 in., inclusive. 1.3 The bolts and studs shall be Type 1; Type 2; or, Type 1 or 2 at manufacturer's option; as specified by the purchaser. When a type is not specified, Type 1 shall be furnished. When elevated temperature applications are involved, Type 1 shall be specified by the purchaser on the order. 1.4 Suitable nuts are covered in Specification A563. Unless otherwise specified, the grade and style of nut shall be as follows: Fastener Size and Surface Finish Nut Grade and Style A 1/4 to 1 1/2 in., plain (or with a B, hex coating of insufficient thickness to require over-tapped nuts) Over 1 1/2 to 3 in., plain (or with A, heavy hex a coating of insufficient thickness to require over-tapped nuts) 1/4 to 3 in., zinc-coated (or with DH, heavy hex a coating thickness requiring over-tapped nuts) A Nuts of other grades and styles having specified proof load stresses (Specification A 563, Table 3) greater than the specified grade and style of nut are suitable.1.5 Unless otherwise specified, washers ordered with bolts shall be furnished to the requirements of Specification F436. 1.6 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information purposes only. |
||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||
|
Doporučujeme:
