Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Test Method for Weight [Mass] of Coating on Aluminum-Coated Iron or Steel Articles
Automaticky preložený názov:
Štandardná skúšobná metóda pre hmotnosť [Hmotnosť] povlaku na hliníku poťahom zo železa alebo ocele Články
NORMA vydaná dňa 1.8.2014
Označenie normy: ASTM A428/A428M-10(2014)
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.8.2014
Kód tovaru: NS-2475
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
aluminum coating, coating weight [mass], steel sheets, steel wire, ICS Number Code 25.220.40 (Metallic coatings)
Significance and Use | ||||||||
3.1 This test method provides a standard method of determining the weight [mass] of coating for comparison with specification requirements. A coating of aluminum on iron or steel articles provides protection against corrosion by forming a relatively inert barrier. Specifications for aluminum-coated articles occasionally provide for different classes (weights) [masses] of coating so that the purchaser can select the coating weight [mass] most suited to his needs. The heavier coating will provide greater protection against mechanical damage which may break the coating. |
||||||||
1. Scope | ||||||||
1.1 This test method covers procedures for determining the weight [mass] of coating on aluminum-coated iron or steel sheets and wire, and on other aluminum-coated iron and steel articles. 1.2 The final results determined by this test method shall be expressed in inch-pound units or SI units, depending on the units used in the material specification to which the results are to be compared. Certain portions of the procedure involving determination of specimen weight [mass] have traditionally been performed in SI units, and corresponding inch-pound units are not included. 1.3 For sheet products, the final results are expressed as either coating weight [mass] total both sides, or coating weight [mass] separately on each side, depending on the specified requirements. 1.4 This standard does not purport to address all of
the safety concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish
appropriate safety and health practices and determine the
applicability of regulatory limitations prior to use.
Standard Practice for Use of the Terms
Precision and Bias in ASTM Test Methods Standard Practice for Using Significant
Digits in Test Data to Determine Conformance with
Specifications Standard Specification for Reagent
Water Standard Practice for Conducting an
Interlaboratory Study to Determine the Precision of a Test
Method |
Historická
1.5.2012
Historická
1.12.2013
Historická
1.6.2012
Historická
1.6.2011
Historická
1.6.2010
Historická
1.11.2011
Chcete mať istotu o platnosti využívaných predpisov?
Ponúkame Vám riešenie, aby ste mohli používať stále platné (aktuálne) legislatívne predpisy
Chcete vedieť viac informácií ? Pozrite sa na túto stránku.
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.