Potrebujeme váš súhlas na využitie jednotlivých dát, aby sa vám okrem iného mohli ukazovať informácie týkajúce sa vašich záujmov. Súhlas udelíte kliknutím na tlačidlo „OK“.
Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare (Includes all amendments And changes 6/18/2015).
Automaticky preložený názov:
Štandard Specification pre oceľové vysielače skrutky, pozinkovaný a Bare
NORMA vydaná dňa 1.12.2008
Označenie normy: ASTM A394-08e1
Poznámka: NEPLATNÁ
Dátum vydania normy: 1.12.2008
Kód tovaru: NS-2356
Počet strán: 6
Približná hmotnosť: 18 g (0.04 libier)
Krajina: Americká technická norma
Kategória: Technické normy ASTM
Keywords:
bolts, carbon steel, steel, transmission tower, weathering steel, Bolting materials, Hexagon-head bolts, Hot-dip (galvanized) coatings--specifications, Square-head bolts, Steel bolting materials--specifications, Structural steel (SS) bolting materials--specifications, Substations, Transmission systems, Weathering steels, ICS Number Code 21.060.10 (Bolts, screws, studs), 29.240.20 (Power transmission and distribution lines)
1. Scope | ||||||||||||||||||||||||
1.1 This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters of 1/2 5/8, ¾, 7/8 and 1 in. for use in the construction of transmission towers, substations, and similar steel structures. The various types of bolts covered in this specification are: 1.1.1 Type 0—Hot-dip zinc-coated bolts made of low or medium carbon steel. 1.1.2 Type 1—Hot-dip zinc-coated bolts made of medium carbon steel, quenched and tempered. 1.1.3 Type 2—Withdrawn in 2005. 1.1.4 Type 3—Bare (uncoated), quenched and tempered bolts made of weathering steel. 1.2 Annex A1 of this specification covers hot-dip zinc-coated steel ladder bolts, step bolts, and support-equipment bolts. 1.3 Nuts and washers that are supplied under this specification that are hot-dip zinc coated shall be in accordance with 4.4. 1.4 Terms used in this specification are defined in Terminology F 1789. 1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.6 The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||
|
Posledná aktualizácia: 2024-11-22 (Počet položiek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.